|
|
The Nylatron "S" Wear Strip |
|
| NYLATRON WEAR STRIPS can be removed and replaced without removing the hold down clips from the cutter bar. Replace the entire set of wear strips in minutes - on the job - no special tools needed - no time loss: using only a pen knife and a 1/2 inch wrench. | |
Use on mowers , Windrowers and Combines |
Use on Flexile Floating Cutter Bars |
# 1050 NYLATRON "S" Wear Strip. |
# 2050 NYLATRON "S" Wear Strip. |
<--------------------------1 7/8" long-----------------> |
<------------------------1 7/8" long------------------> |
 |
 |
.188" thick |
.475" thick |
| Loosen the tension on the spring with the 1/2 inch wrench. With a pen knife pry the old nylatron wear strip out. Install the new nylatron strip and adjust the proper tension on the stern clip. | |
Call 315-834-6647 for Ordering Information |
|